Hello,
I'm not sure if this is the right forum for this question, if not, my apologies in advnce but not sure where to post this otherwise.
I designed a circuit board in Eagle and just had my part delivered. I am trying to solder FS8205 chip onto the board but there's no indication how the chip should be positioned, no dot or anything. The datasheet shows the pinout as per the picture I am including. I also included the link to the actual datasheet. It is a chip that contains 2 MOSFET, so they share the drain but s1-g1 and s2-g2 will not align if I rotate them by 180 degrees. Any ideas?
Thanks.
6 posts - 5 participants