Hello!
I need guidance in using the NRF24l01 pa+lna, the one with the antenna. I have been using them to connect a couple of arduino nano, but without success.
I read the NRF24 library in which i found out the example programme. After using it the problem has been the same with every module i tried from different shops “radio hardware is not responding”. That is supposed to happen due to wiring/connection problems (meaning that the module and the MCU are not “talking”), despite knowing this, check every single wire and use the multimeter to see if there was any shortcut, i could not see the problem.
Does anyone knows what might be happening? Is there anything else i can try?
2 posts - 2 participants