GPIO17 odd behavior in ESP32 WROOM32

I have a custom board with a WROOM32. GPIO17 if used as digital output.
Sometimes, especially at power up, the high-level voltage on this pin is limited to about 2V, even with no load. A reset restore back the normal behavior.

I see in the pins_arduino.h file that is assigned to ETH_CLK_MODE:

#define ETH_CLK_MODE ETH_CLOCK_GPIO17_OUT

but I'm not using the Ethernet module.
From the eth_clock_mode_t enum I see I can choose among:

ETH_CLOCK_GPIO0_IN, ETH_CLOCK_GPIO0_OUT, ETH_CLOCK_GPIO16_OUT, ETH_CLOCK_GPIO17_OUT

but before go for a blind try, I would like to understand what does this setting actually do and if it can really be the root cause of the issue - given that I don't use Ethernet. I have 4 boards, and I see this on all of them.

3 posts - 2 participants

Read full topic