Hello, I have a project for a 2t motorcycle CDI.
In a quick summary of how the CDI works, it takes the electrical voltage generated by the stator, stores it approximately (400v) and discharges it to the coil of the motorcycle to produce a spark.
My question is how I could control the release of the 400v discharge with my arduino atmega. I am trying to modify a generic "racing" cdi that I bought to obtain parts and this same one uses 2 SCR, 2p4m, x0405, how could I connect my arduino to open and close those scr in very fast periods of time? I have seen some ideas but I can't clarify it.
9 posts - 4 participants