Hi, I got an encoder that need to be connected to my arduino to control a NEMA 17 Stepper motor. Could you tell me what power supply I need? Also some additional components like capacitor? Thanks.
BTW, I have ordered two different Nema17 just in case. I'm a bit in rush so I have both.
Driver : DRV8825
Stepstick DRV8825 stappenmotordriver 123-3D 123-3d.nl
https://www.123-3d.nl/pdf/DSD00002.pdf
Motor:
1. NEMA17 stepper motor | 1.8 degrees per step | 48mm long | 4.8kg/cm
Brand: 123-3D Resistance: 1,2
Dimensions: 42.3 x 42.3 x 48 mm (LxWxH) Shaft diameter: 5mm
Voltage: 3 Q Nominal current: 2.5A
Holding torque: 4.8 kg-cm Shaft length: 22mm
Number of wires: 4 Our Item No: DMO00052
2.NEMA17 stappenmotor | 1,8 graden per stap | 40 mm lang | 4,08 kg/cm
Brand: 123-3D Stap hoek: 1,8 °
Dimensions: 42,3 x 42,3 x 40 mm (LxBxH) Nominale stroom: 1,2 A
Voltage: 2,55 V Stappenmotor formaat: Nema 17 info
Holding torque: 4.08 kg-cm As lengte: 22 mm
Number of wires: 4 Ons Artikelnr: DMO00051
As diameter: 5 mm
10 posts - 4 participants
